Orifice plates
-
varnish
- Posts: 10
- Joined: Sun Apr 25, 2010 9:27 am
Orifice plates
Does anyone know if the bolting holes on the PTS orifice plates are the same spacing as the big blue calibration plate/bolting holes for bore adaptor?
-
Brucepts
- Site Admin
- Posts: 1861
- Joined: Fri Jan 08, 2010 3:35 pm
- Location: Pennsylvania
- Contact:
Re: Orifice plates
Yes, they are a 5" square pattern which would be a "standard" flowbench pattern.
The hole diameter is 1/4" and can be enlarged by the end user if need be.
The hole diameter is 1/4" and can be enlarged by the end user if need be.
Bruce
Who . . . me? I stayed at a Holiday in Express . . .
Who . . . me? I stayed at a Holiday in Express . . .