85" flowbench operational

[RACEPUMPER]

I'm not sure if anyone is still tossing up ideas on bench design, but I for one can recommend the pts plans.
My flowbench is now working, calibrated and pulling some big numbers.
This 3 phase 12 motor bench pulls 838 cfm @ 28" and can run at 85".
It is a pts design with material and structural changes to cope with high depression.
This is the fourth bench I have constructed and by far the most accurate and consistant.

Thanks Bruce and Tony for all your help along the way.

[Old Grey]

Which motors are you using.

[larrycavan]

I'm not sure if anyone is still tossing up ideas on bench design, but I for one can recommend the pts plans.
My flowbench is now working, calibrated and pulling some big numbers.
This 3 phase 12 motor bench pulls 838 cfm @ 28" and can run at 85".
It is a pts design with material and structural changes to cope with high depression.
This is the fourth bench I have constructed and by far the most accurate and consistant.

Thanks Bruce and Tony for all your help along the way.

It is an impressive bench. Nice work!

[RACEPUMPER]

12 ameteks Old Grey, 9 x 119996 and 3 x 119998.
And thanks Larry.

Jim

[brandoracing]

Post photo of your beast!