Orifice in a tube
-
MatiasAho2
- Posts: 8
- Joined: Sun Jul 25, 2010 3:34 am
Orifice in a tube
What do you people think about a simple flowbench design where there is just an orifice in a tube? I mean something similar like a PerformanceTrend's "EZ Flow System"...
-
Brucepts
- Site Admin
- Posts: 1861
- Joined: Fri Jan 08, 2010 3:35 pm
- Location: Pennsylvania
- Contact:
Re: Orifice in a tube
Some pretty lengthy discussions in the old forum on this subject but at the present moment we do not have access to that info for reference*.
I know the discussion was pretty much fact that the Cd of the plate in the pipe will change over it's working range. Looking at it from a cost factor for what they charge for the PVC pipe flowbench parts I would go another route for what you get for your money but I'm biased in that view point.
*We are working to recover the old forum posts for reference . . .
I know the discussion was pretty much fact that the Cd of the plate in the pipe will change over it's working range. Looking at it from a cost factor for what they charge for the PVC pipe flowbench parts I would go another route for what you get for your money but I'm biased in that view point.
*We are working to recover the old forum posts for reference . . .
Bruce
Who . . . me? I stayed at a Holiday in Express . . .
Who . . . me? I stayed at a Holiday in Express . . .
-
MatiasAho2
- Posts: 8
- Joined: Sun Jul 25, 2010 3:34 am
Re: Orifice in a tube
Thank you for that, really! I can imagine that there is a lot of work!Brucepts wrote: *We are working to recover the old forum posts for reference . . .