What to do for orifice plate sealing?
-
SWAirflowServices
- Posts: 143
- Joined: Tue Jun 15, 2010 7:51 pm
- Location: So Cal
- Contact:
What to do for orifice plate sealing?
What are people using to seal their orifice plates? One of my customers uses a light grease on his test plates for his SF600. I am just about to finish my PTS bench up and this is one of the last things I need work out.
http://www.facebook.com/SWAirFlowServices You know you want to "Like" it!
-
jfholm
- Posts: 1628
- Joined: Fri Feb 19, 2010 7:36 pm
- Location: Grantsville, Utah 45 min west of Salt Lake City
Re: What to do for orifice plate sealing?
On mine I glued a sheet of 1/8" thick neoprene sheet to the spot where the orifice plate mounts. seems to work fine. I guess you are talking about where the orifice plates mount on the inside of the bench correct?
John
John
-
SWAirflowServices
- Posts: 143
- Joined: Tue Jun 15, 2010 7:51 pm
- Location: So Cal
- Contact:
Re: What to do for orifice plate sealing?
Yes, I am talking about the plate inside the bench.jfholm wrote:On mine I glued a sheet of 1/8" thick neoprene sheet to the spot where the orifice plate mounts. seems to work fine. I guess you are talking about where the orifice plates mount on the inside of the bench correct?
John
http://www.facebook.com/SWAirFlowServices You know you want to "Like" it!
-
Flash
- Posts: 778
- Joined: Thu Feb 25, 2010 3:39 pm
Re: What to do for orifice plate sealing?
I used a o- ring for mine.
Made a groove, glued it in, and then snug them down.
Made a groove, glued it in, and then snug them down.
Gordon
-
Brucepts
- Site Admin
- Posts: 1861
- Joined: Fri Jan 08, 2010 3:35 pm
- Location: Pennsylvania
- Contact:
Re: What to do for orifice plate sealing?
Mine just lays flat on the MDF panel with no seal at all.
Ideally make a gasket that fits your plate and panel hole.
Ideally make a gasket that fits your plate and panel hole.
Bruce
Who . . . me? I stayed at a Holiday in Express . . .
Who . . . me? I stayed at a Holiday in Express . . .
-
blaktopr
- Posts: 622
- Joined: Sat Feb 20, 2010 9:27 pm
- Location: Central NJ
- Contact:
Re: What to do for orifice plate sealing?
I made a cork gasket from Pep Boys.
Chris Sikorski
Chris@wetflowtech.com
Totallywirednow.com
Chris@wetflowtech.com
Totallywirednow.com
-
200cfm
- Posts: 240
- Joined: Wed Mar 03, 2010 10:52 am
Re: What to do for orifice plate sealing?
I use a gasket and 1/4" bolts on each corner followed by a smear of silicone along the outside edge. I cover the head bolt with clay putty to make it smooth to the air. On the calibration plate I lay it in the center of the bore and duct tape the 4 corners down for a firm seal.