PTS Flowbench Forum

very interesting graph, good engineers have created standards, I believe that over the years without world standard metric becomes even in USA.
The new guys of america think now use more metric in school tec?

Stumper you have already defined what will you do? show the process.

Thanks for the input guys, yes I will make my own. I have some sheets of 15mm thick Perspex in the workshop so I will use that, I have some ally tube for corner posts for support and I will go to the local plumbing supply with my verniers and see what I can make work. When I get onto this job I will bust out a thread on how I'm going and get some opinions.

I bought some PVC .500" thick (14 mm) sheet from amazon.com. Oh my it is over $8 dollars cheaper now http://www.amazon.com/dp/B000MAMGFU/ref=biss_dp_t_asn only $22.82 USD now - Since I am doing a small block Chevy I just bought some 4" pvc pipe and used pvc cement and glued it together. Works great and pvc is very easy to work with.

John

What would add to the "collective" would be the hole patterns for various heads???

I'm game for a PTS Flowbench Forum designed head stand for the masses with it's own area on the forum or pinned thread

Sounds good.

Brucepts wrote:What would add to the "collective" would be the hole patterns for various heads???

I'm game for a PTS Flowbench Forum designed head stand for the masses with it's own area on the forum or pinned thread

I can help out a bit with that project. I like the idea of a bolt pattern thread too.

sketch
resembling somewhat, measures which are, or am I very wrong

Hotz wrote:sketch
resembling somewhat, measures which are, or am I very wrong

This is exactly what my adaptors look like in PVC and can be built for about $30-$35
I will try to post a photo tomorrow.
John

Hey, don't tell Sean that !
We can build them and sell them to him for $300 to $350

Hahaha funny lot aren't ya, that pic above is what was in my head, I have a plan now to make bore inserts to for different sizes now, hopefully I will start on that next week some time.