PTS Flowbench Forum

Tested the China power regulator module with 04 motors (6.3A each) for a while today and all worked fine.

Using a 2 poles 63A AC1/AC7 modular contactor.
Before have tested the 04 motors + 12v power supply + chinese power regulator current draw, and got no more than 30A at starting, and then 25a. So the contactor should be fine.

My flow bench building thread to those who would get more details on other aspects

Sorry I have not followed along with your motor control, been a few things going on in life here so the forum hasn't been on my list of reading daily.

I have to go back and look at this control more indepth, looks good!