PTS Flowbench Forum

Used the existing Excel calculator for years to calculate flow vs orifice size and Cd.

I came up with a modified spreadsheet that will allow changing the assumed Air Density
(Inputting Actual Test Conditions) in the calculation vs using the current one in the program.

Where do I send the Spreadsheet (by e-mail) to get it posted for member use?

Tom Vaught

Tom,
At the bottom just below where you post your message here you will see on the left where it says filename. To the right of that it says browse, click on that and just find where your file is and click add file and then it will show up. If You have trouble I will do a PM and send you my email address and I will do it for you

John

You don't have to email it o anyone, you can attach to a post here.Click on "Post Reply" scroll down to "Browse", click on it then navigate to the location of the spreadsheet, click on "Open", then click on "Add the file", wait a few seconds for the file to upload, then click on "Submit"

First let me tell Tom Vaught thanks for this spreadsheet for us. He sent it to me and I will post it here.

John

Thanks Tom Vaught for sharing

Thanks John for posting it

There's that like button Hotz,
I want one too
Jim

Thanks for the LIKE IMAGE. Makes it all worthwhile.

TV

The other info on the spreadsheet was just some documentation on some different benches over the years and checking the average Discharge Co-efficients from the data.

Blow it away if you want.