Page 1 of 1
kart head bench
Posted: Wed Apr 22, 2015 10:28 pm
by robertq
Hi guy's new member here . name is bobby, I have been reading the site few days . its way over my head . lol I need a small bench like sf60 to flow small kart heads . can pts bench be built scaled down to smaller bench . or do you have to build it to exact prints for it to work proper .
Re: kart head bench
Posted: Wed Apr 22, 2015 11:28 pm
by Malvin
Hi and welcome to the PTS Flow Bench Forum
To answer your Question yes you can just build the plenum side of the PTS flow bench
John Holm did it he used 2 shop vacuums. I did try to find his post on it but could not
so I am sure others members here can find it and post the link to it
Re: kart head bench
Posted: Thu Apr 23, 2015 1:37 pm
by Malvin
robertq
I found the link to what John Holm built just the chamber side of the PTS flow bench you can build a
separate vacuum motor box & plumb in to the lower chamber
http://www.flowbenchtech.com/forum/view ... f=3&t=1109