PTS Flowbench Forum

Does anyone know the orifice diameters in Saenz S-600 bench?

Larry, I would PM Curtis Boggs, i think he is using one.

Rick

How about an email contact for Harold Bettes? Last I knew he was consulting/promoting their products.

[quote="larrycavan"]How about an email contact for Harold Bettes? Last I knew he was consulting/promoting their products.[/quoteHere is the contact portal for Harold Bettes
http://www.powertechnologyconsultants.com/contact.php

Thanks for that link

I posted the question over on Speedtalk ......should have known better than that

No Prob, I gave up on Speedtalk when all the knowalls decided any opinion that didn't agree with theirs was a call to attack.

I hear that. Forums were replaced by Facebook and now it's following the same course. I've given up on the human race. Communication is an exercise in futility for the most part...

No Prob, I gave up on Speedtalk when all the knowalls decided any opinion that didn't agree with theirs was a call to attack.

I could not agree with you more.... No more discussion all chest thumping and attacks.

Rick

1960FL wrote:

No Prob, I gave up on Speedtalk when all the knowalls decided any opinion that didn't agree with theirs was a call to attack.

I could not agree with you more.... No more discussion all chest thumping and attacks.

Rick

[Off Topic]I read in Speedtalk but wont comment anymore. I recently had a look at a thread I had taken part in, it is now 6 pages larger and even though I haven't taken part since March or April the attacks and name calling kept coming. I know nothing I say will convince people that I, and others, have a right to an opinion so I see no point in trying to discuss anything there anymore. I look for information and use what is usable but I will remain silent. Now back to our regular programming (Sorry Larry).[/Off Topic]

I got the data! Thanks to Jameson Equipment... the guy with the bench called then and they in turn got the ball rolling...Here's the data in case it helps someone else down the road.

Orifice Sizes Saenz S-600 bench.
1: 24 mm
2: 33.8 mm
3: 46.4 mm
4: 65.6 mm
5: 80.2 mm
6: 90.6 mm