PTS Flowbench Forum

Having issues, sure that it's windows but I can't seem to fix it. This laptop was used for the digital manometer in the past and worked fine, now when I plug the USB in windows assigns com29 or com37 depending upon which port I use but Flowsoft only goes up to com16 so I can't get any data. Suggestions?

I would go into the device manager and manually set the USB com port number?

I do not have a computer here with Windows 10 on it to try out sorry to say.

What's your preferred operating system Bruce? I'm thinking I should just get a dedicated machine for the bench.

My dedicated computer for the software........when i get there, is going to be windows XP......unless Bruce tells me no when i get to that point.

It will work with anything from XP up to current Windows, as we discussed on Facebook it appears to me to be the other software you had loaded that took away all the extra com ports or set it's own port based on what was plugged in asking for a specific port setting.