Pass-Around-Plates (PAP's)
Posted: Sat Nov 06, 2010 8:00 pm
I've had a few questions about the PAP's I sell and what are they?
This was a set of plates that was sent around the USA for testing on various flowbenches, it was a "blind test" and nobody knew what the plates were suppose to flow as calculated. It took a few months for the plates to make it around and was interesting seeing the results.
I have attached a link to the discussion on these plates from the old forum. RESULTS:http://www.tractorsport.com/cgi-bin/for ... ;f=1;t=230
By using a set of these plates one can compare their flowbench to someone else's flowbench and get a good idea of it's accuracy.
This was a set of plates that was sent around the USA for testing on various flowbenches, it was a "blind test" and nobody knew what the plates were suppose to flow as calculated. It took a few months for the plates to make it around and was interesting seeing the results.
I have attached a link to the discussion on these plates from the old forum. RESULTS:http://www.tractorsport.com/cgi-bin/for ... ;f=1;t=230
By using a set of these plates one can compare their flowbench to someone else's flowbench and get a good idea of it's accuracy.