Hi,
Does any one know what the thickness is of the calibration plate that is supplied with the SF-110 (and above) models?
I want to do a little experiment with the plate and my bench that's all...
I hope you guys can help.
Kind regards,
Stef
Also, are the holes sharp edge or is it just a thin plate with straight edges?
Superflow Calibration Plate
-
stef-1
- Posts: 33
- Joined: Wed Mar 03, 2010 11:31 am
- Location: Suffolk, England
-
Tom Vaught
- Posts: 29
- Joined: Fri Apr 30, 2010 12:06 pm
Re: Superflow Calibration Plate
Old Post as far as the question asked but for reference (for the members of the board) the thickness of the orifice plate is .062" plate with a square edged orifice in 2 locations.stef-1 wrote:Hi,
Does any one know what the thickness is of the calibration plate that is supplied with the SF-110 (and above) models?
I want to do a little experiment with the plate and my bench that's all...
I hope you guys can help.
Kind regards,
Stef
Also, are the holes sharp edge or is it just a thin plate with straight edges?
Tom Vaught