PTS Flowbench Forum

..

Larry, when I capture data in the pitot flow sheet, the data captured in the grid gets deleted when I move on to another capture point. The mid section portions of the grid get deleted the most. I've tried capturing in different parts of the 9 possible zones but still getting deletes. Takes many back and forths to finally get all nine cells completed.

Also, is there a way to unlock the password protection. I would like to enlarge the cell and set the sheet up so that the capture gets triggered in the correct cell. Would be nice if end user had some control over the size of the cell.

And can an upgrade be made to offer captured fps values on that pitot sheet with convertion over to fps @ 28" wc. I flow the port at say 15 " wc and make my captures and then have to converted the fps up to 28" wc on paper and sometimes have a drift in the test pressure which can skew the conversion process. thanks.

..

Lap is XP for OS and I had to put microsoft 2010 into it and then added Open Office so it might be related to those two programs as to why it deletes a cell after capturing. I thought also it might be from the hand symbol overlaping into an adjacent cell. I'll PM you on getting the conversion to 28 added on the FPS part of the pitot probe sheet. Thanks

..

..

I have also had some issues when taking a spread sheet created in an early Excel to the new Open Office program. Some cells will not work with the fomula's I had in the cells

Speaking of Open Office it would be interesting to have Flowsoft Excel to run in that application, I tried it but could not get it to run. I did read some on getting the DAQ parts of Excel working in Open Office but that was about as far as I could go with my limited knowledge . . .

..

..