Page 1 of 1
PTS Flowbench build in OZ?
Posted: Wed Nov 20, 2013 8:40 am
by Brucepts
Anyone want to build a PTS Flowbench for a customer in OZ? I have someone looking for one ready to go, chance for someone to make some $$$$'s
PM or Email me if you are seriously interested.
I know a few have talked about it but so far nobody has stepped up to the plate and took a swing.
Re: PTS Flowbench build in OZ?
Posted: Thu Feb 20, 2014 6:44 pm
by Tony
I am not in a position to help, but what state is this customer located ?
Australia is 78% as large as the whole of the USA in square miles, and distances and freight costs here are significant.
Re: PTS Flowbench build in OZ?
Posted: Thu Feb 20, 2014 7:05 pm
by Brucepts
Vic . . . hop skip and jump North from your place actually
Probably could go see it once it's done
It's being built or pretty near done I would hope by now, parts were sent out end of December
Re: PTS Flowbench build in OZ?
Posted: Thu Feb 20, 2014 7:12 pm
by Brucepts
Actually, after looking at the map of your area I have BUNCH of PTS Flowbenches in that area or being built!
Re: PTS Flowbench build in OZ?
Posted: Thu Feb 20, 2014 7:14 pm
by Tony
Ah!
Just realised the original post is now one year old.
I know of a couple of benches being built fairly close.
They are sprouting up like mushrooms all over the World.
Re: PTS Flowbench build in OZ?
Posted: Thu Feb 27, 2014 6:26 am
by RACEPUMPER
It's being built or pretty near done I would hope by now, parts were sent out end of December[/quote]
Yes very close.....
Jim