Quick question. is there an easy way to convert flow numbers to the "Standard Corrected" numbers?
Thanks
Depression / Flow - Flow conversion
2 posts
• Page 1 of 1
by swapmaster » Fri Jan 21, 2005 8:04 pm
- swapmaster
- Posts: 1
- Joined: Fri Jan 21, 2005 2:33 am
- Location: Omaha, NE
by Tom Vaught » Fri Jan 21, 2005 10:51 pm
If you go to the merium web site, click on the manualls section, then look at the manual for the Laminar flow elements, you will find the standard corrections near the end of the manual
Hope this helps.
Tom V.
Hope this helps.
Tom V.
- Tom Vaught
- Posts: 5
- Joined: Sun Jul 08, 2007 11:04 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 14 guests