Tractorsport Flowbench Forum Archive

Posted: **Mon Nov 28, 2005 7:27 pm**

If you were building a bench like the SF 1020 where would you put the orfice hole if the inlet-outlet hole was located on the left side facing the bench?

Does the plenum have to be a certian size?

Should the orfice plate be mounted vertical or horizontal?

Thanks for the help!

Dave

Posted: **Mon Nov 28, 2005 7:47 pm**

Dave, go to the orifice area on the forum and read all the back posts, you will find answers to these subjects. Make sure you go back more than 30 days when you list the posts.

Tractorsport Flowbench Forum Archive

Orfice location