Anybody using these....I have some without calibration charts.
How would you guys calibrate them? Just looking at different ideas
meriam laminar flow elements?
2 posts
• Page 1 of 1
by Thomas Vaught » Sat Feb 24, 2007 2:22 pm
You can get a "As sold new" calibration chart for any laminar
element from Merriam Instruments if you take to the tech guys.
Having one recalibrated after a cleaning can be expensive but the piece would still be deadly accurate then.
If the element has not seen a hard dirty life then the existing calibration chart should be close.
Tom V.
element from Merriam Instruments if you take to the tech guys.
Having one recalibrated after a cleaning can be expensive but the piece would still be deadly accurate then.
If the element has not seen a hard dirty life then the existing calibration chart should be close.
Tom V.
- Thomas Vaught
- Posts: 465
- Joined: Fri Feb 18, 2005 5:36 pm
- Location: Michigan
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests