How To Make a Mold of a Port?
4 posts
• Page 1 of 1
by slracer » Sat May 16, 2009 10:09 am
Greg, You can start here
but many other threads are available if you "Search" the forum. There is a Search button in the upper right corner of the page. Click and continue. -- Doug
but many other threads are available if you "Search" the forum. There is a Search button in the upper right corner of the page. Click and continue. -- Doug
I choose NOT to be an ordinary man because it is my right to be uncommon if I can! - unknown
- slracer
- Posts: 235
- Joined: Mon Sep 01, 2008 10:42 pm
by jfholm » Sat May 16, 2009 10:30 am
Here is a very good article that shows the step by step procedure with pictures. I also use mold makiing urethane from tap plastics that I get online.
John
John
It is a wise man that learns from his mistakes, but it is a wiser man that learns from the mistakes of others.
- jfholm
- Posts: 453
- Joined: Sat Jan 17, 2009 7:12 pm
- Location: Utah, USA
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests