Posted: Tue Jun 13, 2006 7:52 pmI have a dwyer 246 incline and home made vertical. I have the vertical one leg in the upper plenum and the other open to air, I t'd off the upper plenum to one leg of the incline and the other leg to the lower plenum...The problem I am haveing is more than likely operator but the incline appears to be mirroring the vertical??
How do I set the bench to 28" and get a reading on the incline?
I am sure that I am having a brain fart about this, but it has gotten on my last nerve.
The bench is a orfice with 6 115923 with three interchangeable plates, a 112cfm, 225cfm, and 450cfm.
Thanks for your help.
How do I set the bench to 28" and get a reading on the incline?
I am sure that I am having a brain fart about this, but it has gotten on my last nerve.
The bench is a orfice with 6 115923 with three interchangeable plates, a 112cfm, 225cfm, and 450cfm.
Thanks for your help.