Tractorsport Flowbench Forum Archive

Posted: **Sat Jan 14, 2006 6:23 pm**

Diear Sirs!
we want build first bench in Latvia. We recive instruction from uncle jack.now wait from merdoxx.
which bench is better and why?

Posted: **Sat Jan 14, 2006 11:42 pm**

I would personally build a bench based on info and a design from this board.

The Mercdxx mench is basically a clone of a SF bench. There are several good designs recently
that would work as well as far as orifice benches go.

JMO

Tom V.

Posted: **Sun Jan 15, 2006 11:34 am**

Thank's a lot, Thomas.

In Baltic states we have only three benchies, the most powerly is SF-120. I have specialization on VW GM, Honda and BMW enginies from 1,6 till 3,5 liter per 400-700 cm3 per celinder. In spite of my experience, channels processing, i want more.
Now i have question- what bench power i need for such results- engine cilinder pin bore is 90 mm and 11500 RPM with intake manifold?

Anatoli
I will thank's by mean of cpecialists

Tractorsport Flowbench Forum Archive

interesting