flow pipes - flowbench stuff

[cboggs]

I asked this over on Speedtalk but didn't get the reply I was after, ..

There is or was a guy, or company who makes exhaust flow pipes, ..
for flow benches, .. as well as radius inlet guides, .. flow balls, . and
other little flowbench goodies, .. but I can't find them or remember the name.

Anyone know who it is?

Curtis

[PFM]

Curtis,

Some of what you are looking for is on Joe Mondelos site, under porting tools near the bottom, has the exhaust flow pipes. As for the flow balls and such roll your own, some small brass tubing from the hobby shop, some round and oval beads from the craft store a straight pin and JB weld. For the flow flags I feed some fine threads through some brass tubing I make the thread too long and tie it to an O ring on the handle end and can adjust the length of the flag from a 1/4 in stub to inches long streamers.

Maybe I should build this stuff.

PFM

[cboggs]

PFM,

Thanks for the reply, .. yes I have flow balls, a "flow wand" and various other
"tools" for flow testing, ..

There is, or was a guy that made the flow pipes and made one pipe I'm looking for.
It was a special piece for a SB2.2 head that some of the NASCAR guys where
using, .. he also made a radius inlet guide for SB2.2, .. and I need the
parts he made to duplicate some tests for a current project.

Curtis

[Mousehouse1]

I also posted a reply to you Curtis on that other board as well.

Mondello doesn't carry those tubes anymore. The guy making them couldn't or wouldn't keep up so they stopped carrying them. I need a few flow tubes as well. I guess I am going to have to make my own.

[Peter]

Guys...try here