Tractorsport Flowbench Forum Archive

Posted: **Sat Feb 28, 2009 11:21 am**

Hy to everybody, I'm searching drawing or ideas to drawi and make one head adapter, the bore I will use are: 54mm (little more than 2"), 77mm (liitle more then 3 ")and 96mm (little less than 4").
The better material will be acrilic material to have the sleeve transparent too see "inside" the air flow.
If someone have info please post link or plan.
Best regards,
Andrea

Posted: **Sat Feb 28, 2009 12:17 pm**

There is a drawing in this post to give you some ideas

Posted: **Sun Mar 01, 2009 10:03 pm**

Hi

Nice link Bruce , but also have a look at

Brzezinski Racing Products, Inc. make some very nice accessories for flow bench.

cheers

Posted: **Mon Mar 02, 2009 5:47 pm**

So, I have a good idea for starting point.... because I have to work only on single cylinder head (motorcycles) it will be more easy and with less material.
But I finded this web site in AU, do you think it will be a good system?

link:

regards,
Andrea

Tractorsport Flowbench Forum Archive

Info to build a head adapter