Tractorsport Flowbench Forum Archive

by **The Silver Bullet** » Sat Apr 08, 2006 8:38 pm

Do not overtighten the ametek motors if you are clamping them down to a board. The bottom base wil collapse onto the blades....
I wish someone would have told me this before I collapsed (6) 115923 's.....

by **Thomas Vaught** » Sat Apr 08, 2006 11:59 pm

You can carefully take the drums off the 115923 motors and straighten them out. Reinstall them and you will be fine.

I have removed drums and fixed dents in the drums.

Tom V.

by **The Silver Bullet** » Sun Apr 09, 2006 2:39 am

by **Thomas Vaught** » Sun Apr 09, 2006 10:52 am

I have an excel spreadsheet at work on how to do it.

Send me a PM and I will include my work e-mail. I will send you
the excel file.

Tom V.

ps If you want to post it after that on the board then that is fine too.

It is just a cleaned up version of the old MSD schematic.

by **86rocco** » Sun Apr 09, 2006 11:35 am

Hey Tom, could you please send me a copy of that excel file too?

by **The Silver Bullet** » Sun Apr 09, 2006 12:44 pm

by **riga team** » Sun Apr 09, 2006 2:10 pm

by **riga team** » Mon Apr 10, 2006 4:46 pm

I do not know as 115923 motors: but cheap versions - windings are not impregnated by a varnish! Here also vibrate: result-burn!
Anatolij

by **Thomas Vaught** » Mon Apr 10, 2006 8:10 pm

I sent the excel file to you, Silver Bullet.

Tom V.

by **SuperRunner** » Thu Apr 13, 2006 12:37 pm

by **larrycavan** » Thu Apr 13, 2006 10:31 pm

For sealing the motors to the board....two words....Ultra Copper...........nice bead around the motor or the hole..and if you do need to remove the motor, it will separate without too much of a battle and the ultra copper scrapes off pretty easily..

Just replaced some motors that have been in the bench since the early 90's...pretty easy job...

Larry C

by **wing64k** » Thu Apr 13, 2006 10:56 pm

Larry,What part number did you replace your motors with,I have one that needs to be replaced,if I open it up I may replace all 8 any suggestions ?

Dean

PS,Just got new computor,power surge hit house,fried anything that was plugged in,except the bench,lucky

by **larrycavan** » Thu Apr 13, 2006 11:01 pm

I bought some of the 16-1234 motors from the supply warehouse..They're not too bad for the price...

by **wing64k** » Thu Apr 13, 2006 11:03 pm

Same motors I have in the bench now,first failure.

Thanks Dean

by **Thomas Vaught** » Fri Apr 14, 2006 9:06 pm

You can get a motor failure from even the high dollar 115923 motors on occasion. I would not give up on the 16-1234 motors just because one had an issue. JMO

Tom V.

Tractorsport Flowbench Forum Archive

Just a warning for the newbie flow bench builder

Who is online