Scott
again
New cylinder hone.
18 posts
• Page 2 of 2 • 1, 2
by racear2865 » Wed Oct 04, 2006 11:22 pm
- racear2865
- Posts: 9
- Joined: Sun Apr 23, 2006 11:32 pm
- Location: murfreesboro
by Greg » Fri Oct 06, 2006 5:29 pm
Racear, thanks for the pictures. Would you mind posting the schematics for the air system, yours looks a lot less complicated than what I have seen on the Rottler hones!
I'm making up a dummy hone this weekend to set everything up on and check out some ideas I have been thinking out over the last couple of months. Also, what diameter ram did you end up using on yours? I have a ram about 80mm diameter bore and 30mm shaft which I think will do the job.
Greg.
I'm making up a dummy hone this weekend to set everything up on and check out some ideas I have been thinking out over the last couple of months. Also, what diameter ram did you end up using on yours? I have a ram about 80mm diameter bore and 30mm shaft which I think will do the job.
Greg.
- Greg
- Posts: 115
- Joined: Thu Jan 22, 2004 3:24 am
- Location: Queanbeyan, Australia
18 posts
• Page 2 of 2 • 1, 2
Return to Other DIY shop equipment
Who is online
Users browsing this forum: No registered users and 11 guests