Posted: Thu Jan 12, 2006 4:18 pmHow long should they be? I need to make a few of them and need to know how long to make each tube.
Tractorsport Flowbench Forum Archive
Archived Flow Bench Forum
http://tractorsport.com/forum/
Exhaust flow tube
Page 1 of 1
Posted: Thu Jan 12, 2006 4:18 pmPosted: Thu Jan 12, 2006 5:00 pmI believe six to ten inches of straight pipe is fairly typical of what most people seem to use. Maybe about five diameters ?
Posted: Thu Jan 12, 2006 8:13 pmBesides 1 3/4, 1 7/8 & 2" what other sizes should I have made? I mainly deal with small block stuff but would like to get a few sizes for the big blocks.
Posted: Thu Jan 12, 2006 10:40 pm1 5/8
Any tube size bigger than 1 3/4 will require a spread bolt pattern, so consider that into your tubes.
Peter
Any tube size bigger than 1 3/4 will require a spread bolt pattern, so consider that into your tubes.
Peter
Posted: Fri Jan 13, 2006 4:28 amI use a length of exhaust tubing that is 8" to 10" long, with the same diameter and bend as the pipe the motor will run. I may be wrong, but I think the bend influences your port design if the first pipe bend is close to the head. I have seen a slight difference in results between a straight tube and an actual piece of exhaust header on my bench.