Pressure tube location

[cboggs]

Hi guys,

Working on the bench, getting ready to install the pressure tubes, ..
and want to make sure I'm clear on where they go.

The inclined should have one side to the top chamber above the
orifice plate, .. the other side of the inclined to the bottom chamber
under the orifice plate, correct? I'm reading the pressure differential
between the two chambers?

The vertical for the flow depression, .. should have on side going to
the bottom chamber to read the pressure on the orifice plate,
the other end open?

Is this right???


Also, location of the pick ups in the chamber, .. to the side in "clean"
air???

Thanks,

Curtis

[larrycavan]

Curtis,

Test pressure should be read from the top side of the flow disk.

Larry

[cboggs]

Ahh yes, thanks larry

Any ideas about the location in the chambers, ..
off to one side, about 2" from a corner, . ????

Umm, never mind, .. I took the time to read your other posts, :p

Found the one where you did the tests for the pressure tube locations, .
thanks for the info, sharing, helping, etc.

Curtis