Page 1 of 1
Posted:
Sun Jan 29, 2006 1:23 pmby Scott
Here's some pics of yet another small bench, this one will be portable so I can take it to the lake with me on weekends(I cant just lay around all weekend). I will use an FP1, a check on one motor and a 15 amp dimmer (see if it works) I havent cut holes for the deck plates yet or made the orifice fixture, will add pics as I get more done. The design is very similar to Rocco's but scaled down. Enjoy
Posted:
Sun Jan 29, 2006 1:24 pmby Scott
The Box.......
Posted:
Sun Jan 29, 2006 1:25 pmby Scott
Check Valve....
Two inch hinge with ears cut off and new hole pattern.
4" dia. acrylic(plexiglass) flapper.
6" pvc cap, w/3.50" dia. hole cut in.
Make shim for under hinge out of same material as flapper, Assembled with 10-24 machine screws and 6-32 shcs for flapper mount
Posted:
Sun Jan 29, 2006 1:27 pmby Scott
Flow Direction Knob (actual switch for pressure taps in process).........