Posted: Sat Apr 16, 2005 8:10 pmThe attached drawing depicts changes I want to make to my MSD style flowbench. I"m adding a new top, on top of the existing top. The new top section is shown in green.
Dimensions:
36"Length x 14"Width x 3"Hight
The red hole represents the discharge hole in the new top. The existing hole [directly beneath the red one] will be sealed off.
In the existing top, I will make a new 4" hole. My thinking is that it should be off to the right [blue hole]. The air will flow from the top discharge hole, down into the new, added plenium, then through the blue hole into the flow disk plenium.
My thinking is to keep the manometer probe off to the left side where it currently resides, there by isolating it from the flow stream.
The hole on the left [yellow] is an alternate location or possibly a second hole.
I'm looking for opinions before I cut the new hole(s)
in the existing top.
I believe the size of the added plenium will be more than adequate for my purposes.
Best Regards,
Larry
Dimensions:
36"Length x 14"Width x 3"Hight
The red hole represents the discharge hole in the new top. The existing hole [directly beneath the red one] will be sealed off.
In the existing top, I will make a new 4" hole. My thinking is that it should be off to the right [blue hole]. The air will flow from the top discharge hole, down into the new, added plenium, then through the blue hole into the flow disk plenium.
My thinking is to keep the manometer probe off to the left side where it currently resides, there by isolating it from the flow stream.
The hole on the left [yellow] is an alternate location or possibly a second hole.
I'm looking for opinions before I cut the new hole(s)
in the existing top.
I believe the size of the added plenium will be more than adequate for my purposes.
Best Regards,
Larry