Free Chassis Dyno Project!

[craig]

I have most of the components for a Bear Autorol Chassis Dyno for cars. The chassis has been flame cut to separate it into two halves. the unit has four 8 inch rolls and a large air over haydraulic brake. there is no cover to the brake enclosure. It appears to be water cooled were it to have a cover. I have the control panel as well. it is on a 3 ft by 1.5 ft wide roller box with doors and shelves underneath.

This would take some work to put in original condition but prbably has some good parts for a DIY dyno.

If you can haul it out of here, you can have it.

Thanks.

[bruce]

And it would be located where?

[rab]

More than likely not close to me I bet

[Tony]

Is it within easy walking distance of Australia ?

[craig]

Located in Newton, New Hampshire.

Walkable as soon as the bridge linking Melbourne and LA is complete. :;):

[rab]

I knew it would not be in Australia, as no one ever upgrades here, then just gives away the old one:D