![Post Post](./styles/silverwhite/imageset/icon_post_target.gif)
Posted:
Sun Jan 15, 2006 9:32 pm
by bruce
How deep should the sensor be in the exhaust pipe? Any thoughts on this? Does it matter?
![Post Post](./styles/silverwhite/imageset/icon_post_target.gif)
Posted:
Sun Jan 15, 2006 10:16 pm
by Peter
With the standard egt sensors that Superflow supplies, we just drop them into the bungs on our headers. We don't tighten them down at all, we've done this for the past five years without any problems, weather it's ours or Westech's (magazines use them quite offen).