Cylinder head adaptor?
19 posts
• Page 2 of 2 • 1, 2
by bruce » Sun Mar 01, 2009 8:18 pm
Personally, I'd make an adapter that accepts different bore inserts. There is one design on the market like that.
"There is no more formidable adversary than one who perceives he has nothing to lose." - Gen. George S. Patton
- bruce
- Site Admin
- Posts: 1638
- Joined: Sun May 09, 2004 12:17 pm
by Tim H » Mon Mar 02, 2009 3:26 pm
Being new to the forum and working on reading as much as possible in the shortest amount of time, I'm not sure if this has been brought up somewhere else, but here goes...
I read somewhere (not sure where right now) that a good probe-type tool is a string or a thread and if you make your cylinder head adapter clear, you could "sail" your thread into the intake port and see where it comes out the valve. Might help in locating "dead" spots.
So...I'm for a clear one!
I read somewhere (not sure where right now) that a good probe-type tool is a string or a thread and if you make your cylinder head adapter clear, you could "sail" your thread into the intake port and see where it comes out the valve. Might help in locating "dead" spots.
So...I'm for a clear one!
- Tim H
- Posts: 1
- Joined: Sun Mar 01, 2009 4:01 pm
by racehead-1 » Mon Mar 02, 2009 4:14 pm
Well Daniel... even with the biased cut the air will have the tendency to get turbulent.
Bruce, where is this adapter that accepts diffrent bore inserts? Is it possible for you to post a pic. .
Bruce, where is this adapter that accepts diffrent bore inserts? Is it possible for you to post a pic. .
- racehead-1
- Posts: 30
- Joined: Mon Mar 10, 2008 7:29 am
- Location: Portugal
19 posts
• Page 2 of 2 • 1, 2
Return to Flowbench techniques
Who is online
Users browsing this forum: No registered users and 3 guests