A place to post links to your flowbench projects to share with everyone on the board. You can share a description and pics also here please limit the size of your picture files to low res pics, Thanks
by WPH » Sat Mar 15, 2008 4:17 pm
This is my motor centered orifice flowbench, still unfinished but fully operational. I had to start testing since we are running out
of time on our "weekend racer" project. Scrap head in the picture is from 2 litre Peugeot EW10J4 engine, 33x29 valves.
Stock bare port flow was rather low, only 123.6cfm@10". I have done some porting before but I haven't been able to verify results.
It was nice to see which mods gained most flow and I was surprised of the results. An hour later BPF was already 133.1cfm
and I hardly removed any material... It seems I'm going to move into my garage...for a long time 
Pekka
-
WPH
-
- Posts: 81
- Joined: Thu Oct 18, 2007 3:20 pm
- Location: Kuusamo, Finland
by bruce » Sat Mar 15, 2008 4:53 pm
"There is no more formidable adversary than one who perceives he has nothing to lose." - Gen. George S. Patton
-
bruce
- Site Admin
-
- Posts: 1638
- Joined: Sun May 09, 2004 12:17 pm
-
Return to Readers Flowbench projects
Who is online
Users browsing this forum: No registered users and 7 guests
