Page 1 of 1
Posted:
Sun Aug 01, 2004 10:10 pmby Bill
Hi... listed below is a link to an article on a bench that I just complete. Thanks to all of you on this board for the info you have posted. It was more than enough to get me on my way!!
Write up and pictures are here..
Posted:
Mon Nov 15, 2004 3:39 pmby Rik (the Netherlands)
Hi Bill,
i must admit that your bench looks tha bomb. I hope it works as good as it looks , nice job.
But could you tell me more about the pitot tubes you have used? (sizes, diameter)
thanx Rik
Posted:
Tue Nov 16, 2004 12:29 pmby Bill
Looks great, I'm in the process of building an orifice flowbench modeled after the PHR magazine '93 bench. Where did you get your inclined manometers and what make/model are they?