Should pull more air with 4 motors, unless they are not the same. I can get just about exactly 28" @ 230 SCFM with 3 of those el cheapo No. 16-1234 motors from surpluscenter.com.
What are you flowing? Intake or exhaust?
John
help with my averaging pitot tube
17 posts
• Page 2 of 2 • 1, 2
by AM91Camaro_RS » Wed Mar 09, 2005 1:02 am
i have two motors that look just like item number 16-1193-C on that same web site. the other two are slightly bigger. i don't know where my problem is then.
i was trying to flow intake. i tried exhaust but i don't have all of my pipes glued yet and i blew a couple of them apart. i'm pretty sure that my head probably isn't sealing completely on my bench top so, i'm losing a little there. however, when i tried to go to .300" lift. i was only able to pull about 20" if i remember correctly. do you think i could be losing that much through bad seals?
i was trying to flow intake. i tried exhaust but i don't have all of my pipes glued yet and i blew a couple of them apart. i'm pretty sure that my head probably isn't sealing completely on my bench top so, i'm losing a little there. however, when i tried to go to .300" lift. i was only able to pull about 20" if i remember correctly. do you think i could be losing that much through bad seals?
- AM91Camaro_RS
- Posts: 12
- Joined: Tue Feb 15, 2005 3:18 pm
- Location: Florida
17 posts
• Page 2 of 2 • 1, 2
Return to Pitot Style Bench discussion
Who is online
Users browsing this forum: No registered users and 1 guest