Tractorsport Flowbench Forum Archive

by **wing64k** » Wed Feb 01, 2006 11:30 pm

When measuring a port with calipers is there an industry standard where to measure,for example should the ssr be measured at the center or more towards the seat or inlet or say for the throat at the base of the seat or closer to the valve at the bottom angle.

Dean

by **larrycavan** » Thu Feb 02, 2006 9:41 am

Dean

I personally measure the port lengths from the bottom of the seat cut and the throat diameter at it's smallest point which is generally at the bottom of the inside cut.

I'll email you a paper on different ways to measure port areas.

Larry C

by **Mousehouse1** » Thu Feb 02, 2006 10:31 am

Can you send that paper to me as well Larry?

by **86rocco** » Thu Feb 02, 2006 11:51 am

by **hollywood63** » Fri Feb 03, 2006 9:07 am

Larry
Ditto

by **swolds** » Sat Feb 04, 2006 3:27 am

me too please

by **cboggs** » Sat Feb 04, 2006 11:57 am

larry, .. me too on the paper if you don't mind

curtis

info@raceflowdevelopment.com

by **Scott** » Sat Feb 04, 2006 5:01 pm

Larry, would you be so kind.....me too

by **swolds** » Sat Feb 04, 2006 7:36 pm

by **PerformancePorting** » Sat Feb 04, 2006 9:00 pm

I would like that also if you don't mind. Thank you in advance. fastheads@comcast.net

by **bseibenick** » Sat Feb 04, 2006 10:45 pm

I would like a copy as well.

brian@mph-racing.com

Thanks,
Brian

by **Hopper** » Sat Feb 18, 2006 1:48 pm

Me too!!!
finnrm@msn.com

by **riga team** » Sat Feb 18, 2006 4:21 pm

larry, .. me too on the paper if you don't mind gabtmotors@inbox.lv

by **SuperRunner** » Thu Feb 23, 2006 1:39 pm

ditto if you don't mind. robertj@linux4free.com

by **gavinator68** » Wed Sep 05, 2007 7:17 am

me too Larry...........please : )

david@diyaudiosupply.com

Tractorsport Flowbench Forum Archive

Measuring ports

Who is online