PTS Flowbench Forum

Hi,

Does any one know what the thickness is of the calibration plate that is supplied with the SF-110 (and above) models?
I want to do a little experiment with the plate and my bench that's all...
I hope you guys can help.


Kind regards,

Stef

Also, are the holes sharp edge or is it just a thin plate with straight edges?

stef-1 wrote:Hi,

Does any one know what the thickness is of the calibration plate that is supplied with the SF-110 (and above) models?
I want to do a little experiment with the plate and my bench that's all...
I hope you guys can help.


Kind regards,

Stef

Also, are the holes sharp edge or is it just a thin plate with straight edges?

Old Post as far as the question asked but for reference (for the members of the board) the thickness of the orifice plate is .062" plate with a square edged orifice in 2 locations.

Tom Vaught