new member information?

[force 1]

Hi guy my name is Pat !
I am new member!
I want to build my own flowbench!
So that i can test the head of motorcycle!
Does anyone has any information and or a sketch to build a baseline flowbench?
thanking you in advance!
Pat.

[84-1074663779]

Welcome to out group Pat, you have certainly come to the right place for that.

This Forum is the third Forum we have had, and is just getting up and going again. Check out the "Flowbench Links" topic a bit further down the page. There you will find all the posts on the two previous Forums.

Spend a few hours reading through it all, there is some terrific information buried in there. There is an answer to just about every question, but you must hunt for it.

Cheers, Tony.

[kick]

Hi guys, I'm also new to this group. I'm looking into building a flowbench. I actually built one a long time ago and I also had a SF-110 for 5 years.
What's your thoughts on the article in Popular Hot Rodding in Sept. 93 on building a flowbench? I ran across it this week and it looks a lot like a SF-600. I have part numbers and prices for Dwyer manometers and Granger motors at reasonable prices.
Has anyone seen this design work? Any other links to similar projects? Link below for PHR article.
Thanks,
Jim