If you were building a bench like the SF 1020 where would you put the orfice hole if the inlet-outlet hole was located on the left side facing the bench?
Does the plenum have to be a certian size?
Should the orfice plate be mounted vertical or horizontal?
Thanks for the help!
Dave
Orfice location
2 posts
• Page 1 of 1
by bruce » Mon Nov 28, 2005 7:47 pm
Dave, go to the orifice area on the forum and read all the back posts, you will find answers to these subjects. Make sure you go back more than 30 days when you list the posts.
"There is no more formidable adversary than one who perceives he has nothing to lose." - Gen. George S. Patton
- bruce
- Site Admin
- Posts: 1638
- Joined: Sun May 09, 2004 12:17 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests