Diear Sirs!
we want build first bench in Latvia. We recive instruction from uncle jack.now wait from merdoxx.
which bench is better and why?
interesting
3 posts
• Page 1 of 1
by Thomas Vaught » Sat Jan 14, 2006 11:42 pm
I would personally build a bench based on info and a design from this board.
The Mercdxx mench is basically a clone of a SF bench. There are several good designs recently
that would work as well as far as orifice benches go.
JMO
Tom V.
The Mercdxx mench is basically a clone of a SF bench. There are several good designs recently
that would work as well as far as orifice benches go.
JMO
Tom V.
- Thomas Vaught
- Posts: 465
- Joined: Fri Feb 18, 2005 5:36 pm
- Location: Michigan
by riga team » Sun Jan 15, 2006 11:34 am
Thank's a lot, Thomas.
In Baltic states we have only three benchies, the most powerly is SF-120. I have specialization on VW GM, Honda and BMW enginies from 1,6 till 3,5 liter per 400-700 cm3 per celinder. In spite of my experience, channels processing, i want more.
Now i have question- what bench power i need for such results- engine cilinder pin bore is 90 mm and 11500 RPM with intake manifold?
Anatoli
I will thank's by mean of cpecialists
In Baltic states we have only three benchies, the most powerly is SF-120. I have specialization on VW GM, Honda and BMW enginies from 1,6 till 3,5 liter per 400-700 cm3 per celinder. In spite of my experience, channels processing, i want more.
Now i have question- what bench power i need for such results- engine cilinder pin bore is 90 mm and 11500 RPM with intake manifold?
Anatoli
I will thank's by mean of cpecialists
- riga team
- Posts: 112
- Joined: Sat Jan 14, 2006 2:05 pm
- Location: latvija
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests