Has anyone tried this or is it just a wifes tail. Over on Speed the was a short discussion on it but few of the top porters commented. In therory it sounds good or is it just putting a band-aid on a major wound.
Art
Dimpling the SSR
2 posts
• Page 1 of 1
by hollywood63 » Mon Jun 26, 2006 1:26 pm
- hollywood63
- Posts: 59
- Joined: Mon Nov 15, 2004 10:25 pm
- Location: U.P of Michigan
by Scott H » Mon Jul 03, 2006 1:39 am
It's not new, I believe Ken Sperling was playing with it 15 years ago (if not 20). The idea was to make the port short turn radius act like a golf ball where the dimples assist in loft.
It might have helped on factory iron heads where the short turn improvement options were; add metal by welding, add epoxy, or dimple the ssr. I don't pretend to know if it worked-- I never tried it.
It might have helped on factory iron heads where the short turn improvement options were; add metal by welding, add epoxy, or dimple the ssr. I don't pretend to know if it worked-- I never tried it.
- Scott H
- Posts: 49
- Joined: Wed Jun 28, 2006 6:41 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest